Doyon JAOP12SL User Manual download pdf (Page 14)

A-11

OPERATION OF THE PROOFER

1. Switch "ON" (1).

2. Set the thermostat control at 100° F.

3. Set the humidity control at approximately:

3 for JAOP-3 & JAOP-6

4 or 5 for JAOP-10

5 for JAOP-14

4. If there is too much fog and water drips from the glass doors,

adjust humidity control to a lower number.

5. When the temperature is stabilised, put the products in the proofer.

(Leave them inside until they are ready to bake.)

6. IMPORTANT: When proofing cycle is completed, turn the

humidity switch to "OFF" and let the motor blower and air heat

element run for 10-15 minutes to let dry the proofer. Then, turn the

main switch ‘’OFF’’ (0) and leave the door ajar to prevent moulding.

When the proofer is not in operation, open the doors to let out the humidity and to prevent

mould.

P.S. The doors should not be opened unnecessarily to conserve the heat and humidity in the

proofer.

Every day cleaning of the water pan under the proofer's doors should be exercised.

POWER FAILURE

When the power comes back, the proofer will start automatically. Then it’s recommended to turn

OFF the unit to avoid it starting without supervision.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

No comments

Doyon JAOP12SL User Manual Page 14